How To Cut Crown Molding
Crown molding is a decorative way of hiding flaws between the ceiling and the wall. It is also used for stylish appeal. Usually crown molding is cut so it will be a specific angle and joined to the wall where corners aren’t in place. Crown molding has an elegant charm that will display really beautifully in any home. Read on to learn about how to cut crown molding and other crown molding installation tricks.
Materials That You Will Need for Crown Molding Cutting:
- Safety Goggles
- Measuring Tape
- Milter Saw
- Crown Molding
- Wood Putty
- Nails/Nail Gun
1. Cut To Fit Into Corners
- At a 45 degree angle you can cut the crown molding by holding the wall side/bottom edge against the bottom back edge of the saw base and back plate. Set the saw to cut at a 45 degree angle and cut carefully.
- Cut the opposite angle on the other part of the crown moulding.
- You can also cut the crown moulding to fit into the corners by holding it flat against the saw and adjusting the angles to 31.62 degrees and also 33.9 degrees.
2. Fit Together
- With the crown molding against the back plate, hold it flat and set the saw to a 45 degree angle on the inside of the first molding piece and then cut.
- Do this again for the other piece.
- After both have been cut, see if they fit tightly together and do not leave any gaps.
3. Installation Tricks
- Only use a few 6D or 8D nails to attach the crown moulding.
- Take your time with this. It can be frustrating so be sure you allow yourself extra time and budget money in case any unexpected situations occur.
- Always keep the surface area that you are working in clean.
- Make sure there is a solid nailing spot where the joists run parallel to the crown moulding. Use a 2×2 cut on a 45 degree bevel. Cut the 2×2 and then screw it to the wall where the corner of the ceiling and wall meet. Using a 2×3 makes sure the surface is solid and sits at an angle where you can nail.
- Use wood putty and fill in any holes and sand smooth.
- Get assistance from another person, it’s always good to have an extra pair of eyes when completing these type of tasks.
The proper procedure of cutting crown molding involves a lot of time and patience. You should always be sure that you have the right equipment on hand and another experienced handy person to assist you. Now that you are more aware of how to cut crown molding you will have less to worry about when you install it.
Any questions? Call Home Painters Toronto and they can help you out! Call us NOW at 416-494-9095 or email [email protected]!